Recent content by MMitchell2020

Thanks Khay, To be clear, stealthchop was not enabled, my belts were over-tensioned. These motors can handle 0.85N vs the std 0.55N, so I had assumed I was on point. I also noticed that as temps increased the issue would worsen, so I reduced my driver run current to 1.8a vs 2.2a. The issue...

Hahahah, Thanks Khay, I'll make sure to clean it up before my next post. Regardless, the motor resonances/tuning makes the most sense. I'm likely over-tensioning the belts or overheating the motors. The enclosure usually hits about 50C with the bed at 100C. I'm aiming for a high temp setup...

I realize this post may be out of the ordinary for this forum and my build looks atypical, but wanted to post just in case. I've been dealing with this issue for some time and troubleshooting what may be the cause, where during xy movements, I hear sliding/grinding from what seems to be the...