Recent content by ModifiedMatter

Ok, you were right. My stepper A was inverted which caused the x to home straight back. After fixing that, I passed a QGL. Thanks for the help.

Thanks guys for reading my request and offering such valuable information. In my own research, I found this article from Ellis which describes a gantry squaring procedure: https://ellis3dp.com/Print-Tuning-Guide/articles/voron_v2_gantry_squaring.html I'm using a lightweight x beam which...

Yes, my x axis homes to the right and my y axis homes to the back. I have been using the start up guide. I'm at the part where you do a QGL.

Front left, front right, back right, back left.

Update: I tried checking more bolts, found a few that could have been torqued down a bit further. Tried to level again and it consistently will dip the back left corner which makes the front right corner not be able to reach the bed. This was the last thing that happened followed by a "Probe...

Ok so the gantry motors move together when homing the z or doing z movements. But during a QGL rather than moving in ways that would actually level the gantry, it moves in ways that move it out of wack and ruin everything.

Hopefully someone can help me. I'm kind of a noob but I did build a v0 and a Trident. My 2.4 that I'm building does one of two things during a QGL: 1. Will abort and say "Retries aborting: Probed points range is increasing". I have checked the motor wires multiple times to make sure the right...