Recent content by mpzr

Thank you for the further information. All seems to work ok in practice except the heat-break fan is very noisy initially. Once up to temperature if I just touch the face of the fan lightly it suddenly runs up to speed and quietly. I may try the manual control method to see if that's different...

Thank you for your input. Both Stealthburner fans i.e. hotend fan and print cooling fan. M106 S100 for example sets both fans to a low speed but I assume we need the hotend fan to run faster when printing. If klipper doesn't use the "p" parameter how do we address individual fans?

Voron 2.4r2 with RPI5, Octoprint and a Spider V2.3 mainboard. Slicing in Cura. Set fan off in Cura but print cooling fan runs anyway. I've been experimenting with M106/M107 in the Octo terminal with e.g. M106 P0 S100 but whatever I do both fans respond equally. Yes I have checked the wiring from...