VORON Design
Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members!
Recent content by Mykola
-
M
Cumulative layer shifting on a Voron 2.4 r2
The current is set to 0.9 A, speed is 150 mm/s, and acceleration is 5000 mm/s². I’m using TMC2209 drivers.- Mykola
- Post #5
- Forum: General Voron Chat
-
M
Cumulative layer shifting on a Voron 2.4 r2
The diagonals of all sides of the cube are as equal as possible +/- 0.2 mm- Mykola
- Post #3
- Forum: General Voron Chat
-
M
Cumulative layer shifting on a Voron 2.4 r2
Hi everyone! I’m having an issue with my Voron 2.4 R2 (350x350x350) – I’m seeing cumulative layer shifts during long prints (the longer the print, the more the shift is visible on the X and Y axes). Hardware setup: Mainboard: BIGTREETECH Manta M8P V2.0 with CM4 Toolhead board: EBB SB2209 (CAN)...- Mykola
- Thread
- Replies: 5
- Forum: General Voron Chat