Recent content by NC0C0C

Also, I use them because I saw Stratasys using these type of belt in their printers, and it is said that these belt are tend to be less stretched.

they are Polyurethane belt and B motor here

Thanks for your reminder, and I took a picture of by A motor

It is just too troublesome to take the acrylic sheet at the back down. If you mean to see if the belt and the wheel are lined up, I may say yes for that.

I faced a weird situation with my Voron 2.4: when my X axis was moving along my Y axis, in the y=350 to about190, the print head was moving straightly, when y=190 to about 50, the print head started to slope to the left hand side for around 5mm, and during the last y=50 to 0, it began to move...