VORON Design

Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members!

Recent content by Neomonkey

  1. Neomonkey

    X and Y Home but STEPPER_BUZZ doesn't do anything

    I figured it out i didn't have an ! in front of the enable pin which turned them off by default. Still on the Z probe tap always being triggered though.
  2. Neomonkey

    X and Y Home but STEPPER_BUZZ doesn't do anything

    I'm at the initial startup phase of my formbot kit Voron 2.4r and I'm looking to get into the technically printable phase this week. I got to the motor check of the initial startup guide and the STEPPER_BUZZ command doesn't do anything. The X and Y axis will home so I'm pretty sure everything is...
Top