Recent content by npowers

So I did a recompile with the disable pins setup and the problem persists. Next step is a new controller board.

I am looking for @cosminr86 Do you remember where in menuconfig you were able to invert the enable pins or were you setting the stepper motor enable pins in the GPIO section? PE9 for X, PD9 for Y

Ok, I'll get working on that. Since I am doing a recompile is it worth updating Klipper at the same time using KIAUH? My system is currently on v0.10.0-557.

1. Motor stop vibrating but whichever motor was plugged in to M0 starts to have the vibration issue making me think it is an issue with the channel on the Spider board. 2. No change, B motor remains the one that is vibrating 4. I swapped everything to channel M7 and the vibration stopped 5. I...

I'll take a look and see if this can correct it. What makes me wonder though is the issue is only on one channel of the entire board. Did you see an issue with only the enable pin for channel M0?

Hi, I have finished building and am currently tunning a Voron 2.4 350mm kit from Siboor. The printer successfully prints, and I have managed to get it well tuned but have one remaining vexing issue. At the initial flip of the power switch one of the stepper motors begins to vibrate like it is...