Recent content by OkieVet

Not intending to sound like a smartalec but I gotta ask, did you use a thread locker like Lock-Tite or Permatex on all your T-nuts for at least the frame and gantry? I used the blue stuff for things that might need to be re-adjusted later - can be removed without heat, and red for more...

Well, any tool board with SB in the name such as SB2209 is a 2 piece board designed specifically for the Stealthburner, so yeah, you're sort of married to the SB. That being said there's an adapter on Printables that will allow you to mount the SB2209 on the back like an EBB36. Personally I...

Siboor Voron 2.4r2, BTT Octopus Pro 1.0 + BTT SB2209 RP2040 + Cartographer. I've attached my printer.cfg but the relevant sections regarding Cartographer are below. Cartographer supposedly is already flashed but I would do it since there may be newer firmware especially if you're using a...

You likely will have to reflash the firmware to the Manta as a minimum because in all likely hood that is where the problem is and not the RP2040 as it's popping up in klipper mode indicating it has Klipper already on it. The Manta board is the USB to Can bridge. As I understand it, the USB...

If you're fine with dealing with aliExp, kits there start around $750 for a relatively bare bones 250 x 250, and if you get the full printed parts set that typically adds another roughly $120. Going up to a 350 x 350 will tack on about $120 so, you're still around 1k, but with free shipping...