Recent content by pad31

I finally found the root cause !!!!!!!!! The insert on which one the thumbscrew has to be screw was bad... Because of this i did not screw enough the thumbswew (as it was blocked quickly in the insert whereas i though it was because of the spring tension ) => the tension on this specific...

Hello i've an issue with the Galileo 2 extrduer maybe someone could help... Everything was fine until i switch my filament from ABS to PLA (polymaker polyterra PLA ) it start having some inconsistent extrusion . I change the complete hotend + nozzle without improvement. I then dismantle...

Good morning i've spend a lot of time trying to set up CANBUS using a BTT SB 2209(RP2240) with a USB to CAN board (U2C from BTT). i connected the 24V +GND to the U2C then the SB2209 to the U2C with the CAN cable . When i Power on , the SB2209 burn exactly on the chipset ...whereas led was fine...