VORON Design
Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members!
Recent content by pakerfeldt
-
EBB SB2209 CAN V1.0 (RP2040) + Voron Tap = Will not trigger Z endstop
Did you manage to solve this? I seem to run into the exact same issue with my TAP and EBB RP2040. I've measured resistance over S and G and I would assume it's correct since it changes from 200 Ohm to 1k Ohm when triggered. However, I cannot read the state in Klipper for some reason.- pakerfeldt
- Post #2
- Forum: Electronics
