Recent content by Pendorbound

That’s a known issue with the SKR Pico. See https://github.com/bigtreetech/SKR-Pico/issues/2 and https://klipper.discourse.group/t/rp2040-pico-suddenly-unable-to-connect-usb-issue/2554. I’ve had mixed luck using a gpio pin from my Pi to toggle the reset pin on the Pico before Klipper startup...

I have, but I also use a nozzle tip probe in my v0. It seems like the lesser evil is heating up the hot end enough that any cling-on’s melt so they don’t affect the the nozzle offset when it probes.

I’ve used both a Dragon high flow and a Dragonfly in mine. I was hoping the Fly would ooze less than the high flow during preheat, but it doesn’t look like there’s any difference. Both of them print really well at pretty good speeds.