VORON Design
Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members!
Recent content by philt79
-
P
Slicer Temp settings not going to Voron 0.1 printer
Hi Claudermilk, I think I got to where I needed to in the Cura settings, but it's not taking effect. I'll try a few more changes in this area as I may not have got it all correct (obviously). Your suggestion seems to make sense though! I'll give it another try over the weekend.- philt79
- Post #7
- Forum: General Voron Chat
-
P
Slicer Temp settings not going to Voron 0.1 printer
NoGuru, thanks for the advice. I've just set up Orca and doing a calibration test, but the intended PETG temperatures (255deg Extruder and 80deg Bed) are still not being applied on the printer. Rather, the default temps from the printer config file of 220deg and 80 deg are being used??? I was...- philt79
- Post #3
- Forum: General Voron Chat
-
P
Slicer Temp settings not going to Voron 0.1 printer
Hi, brand new newbie here - to 3D printing and GCode works. I've built and got my Voron 0.1 going and printing PLA quite nicely. The config file has default temps of 60 deg for the bed and 220 deg for the extruder - see attached sample of config file. When I change my profile in Ultimaker Cura...- philt79
- Thread
- Replies: 7
- Forum: General Voron Chat