VORON Design

Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members!

Recent content by Phreakhcker

  1. P

    Troubleshooting frequent hotend clogs or extruder skipping

    Yes it is supposed to run all the way to the toolhead. Any folks you see with just a small piece of bowden tube out the toolhead will be asking questions at some point why their extruder is "clogging' or "stops extruding" which goes back to the OP's number 4 again.
  2. P

    Solved Heat insulation necessary to avoid bending the acrylic bottom panel?

    I printed a few extra of the deck panel clips for my formbot machine I built that seemed to want to warp more. I clipped them under the machine and clipped some above the machine as to keep the plate sandwiched between it. I believe I put about 8 of them at the top and 8 at the bottom. Works...
  3. P

    Heater heater_bed not heating at expected rate

    If replacing the bed thermistor (I've had to replace one of mine a while back) follow these simple instructions. Just don't try and remove or cut into the heater mat is the main thing. Here is instructions from Keenovo. 1) Cut the two small red PTFE sensor wires( usually 22AWG), some Keenovo...
  4. P

    Solved Voron 2.4 300mm Belt moves up on B Drive Corner

    I just want to point out that the stock idlers work perfectly fine as well. You can also adjust them as to make sure the belt is not sent high or low to the back bearings on the a and b drives. By loosening the big m5 bolt and slightly turning the tensioner by hand then applying a slight amount...
  5. P

    Welcome to the new Voron Forum!

    Well well! I like it!
Top