Recent content by pigsy2001

I recently finished building a Formbot V0.2r1. The foam tape doesn't seem to be a part of BOM. But, I used it in the same way I did for building V2.4. Here are complications I encountered: - Magnetic door does NOT close properly due to increased gap from the foam tape. I had to use two 2mm...

I am new to Voron also and agree with other posters: z axis idlers. I had to replace two of originals s they were broken and later replaced all with CL CNC version. In addition, tool head is one I’d have a a back up.

I have a chaotic lab cnc tap with 2 piece pcb set up. I had to mod & re wire to supply 5v but it was not that difficult at all. Tap is really awesome !

I cannot agree more: my dongle just died. But before it’s death, the dongle frequently lost wifi connection especially when mks pi heats up. I ordered the same from Ali but wish I know if there is an alternative

I like this 2x4 table, and I amalso curious about the plastic filament bag you are using. Can you share what you are using?

I am also new to Voron. Your description is very similar to what I also experienced. I agree with other posters advice. In my case, all the following helped alot, so finally now I can start print and leave. - heat soaking is essential. I use 4x 5015 fans under the build bed - Ti backer rods...