Recent content by PrintMeUpScotty

Best I can tell, this is failing on trying to home after QGL. In klippy, it's after a SET_KINEMATIC_POSITION pos=300.000,25.000,1.000 set_homed=z clear_homed=, which I think is my homing override, but I cannot figure out the root cause of this to save my life. Any ideas? This is an LDO V2.4...

For anyone in the future, it's fine. :)

Hi everyone, I ordered 24v RGBWs for my chamber lights only to just now realize the power and data share a ground. Is it going to cause issues for me to use the RGB output of the Manta M8P V2 and combine the RGB output ground with the 24v power supply output ground? Those aren't isolated or...

I did. I ended up moving to a different motor channel and it worked great!

I am trying to setup sensorless homing on my new Voron 2.4. I was able to get X, but Y wasn't cooperating... turns out the endpoint was triggered. I have checked for the endpoints to be defined in the other configs, but nothing there. I am at a bit of a loss with this one. Manta M8P 2.0 with...

Thank you!

This is great! Is it still going or has it changed? Also, what blue did you use with that printer? That's a killer blue!