Recent content by PrplMshrm

If anyone is interested, the Z motor brakes work well. There's a Nero3D video about them here. Here's my brakes.cfg file: [output_pin brake_pin] pin: PF9 value: 0 shutdown_value: 0 [delayed_gcode my_delayed_gcode] gcode: SET_PIN PIN=brake_pin VALUE=1 set_stepper_enable stepper=stepper_z1...

Hey that fixed it! Thank you.

OK I fixed my issue and I'm now happy with this controller board. I looked at the klippy log file and the errors were due to running out of buffer space. I found a typo in the can config file (/etc/network/interfaces.d/can0). Now everything is working great.

Well, I rebuilt my printer with the leviathan and canbus to the tool head. Everything is working as it should. Problem I'm having is within a minute of printing, I get the dreaded "MCU shutdown timer too close." Also, LDO claims that the dedicated led strip light port for your case lighting is...

PG7 cable gland with steel wire guide fits.

I can confirm that Galileo 2 is compatible with BTT SB2009 can toolhead board. everything fits without modification.

Got my Leviathan up and running on the bench with a BTT SB2209 toolhead board. Took me a while to get everything flashed and working in Klipper. This is my first time messing with canbus. Waiting on some wiring and connectors before transplanting in my V2.4. The documentation is still a bit...

I'm doing a similar upgrade. Just picked up the LDO Leviathan controller and an EBB SB2209 toolhead board. The Leviathan has built in USB to CAN bridge and a spot to mount the PI. Took me a while to get everything flashed and configured on the bench but it's all working now. Looking forward to...

I recently upgraded my clockwork 2 of my Voron 2.4 300mm to the Galileo 2. The clockwork 2 was capable of consistent extrusion BUT was fiddly and if I used the filament latch to load and unload filament, the anti-squish screw would go out of adjustment. I'm getting much more consistent extrusion...