Recent content by pws

Long time, no writing. Got his serial, so today he is named Goldie V2.7471 and this is what he looks like now: However, there are still some issues. I had the CAN-error popping up again, when I started to add the Creality printer to the host. So, they had to run separately. Ubuntu got updated...

Input shaping. Looks ok. The X-axis has two parts that I will later dig into. The "small bump" before the top and then the "edge" right before it smooths out. The Y-axis is outstanding. I followed the recommended shaper profiles and set max acceleration to 5300. Ellis tuning guide, was...

Ok, CAN problems! As soon as I start probing, either when doing Z-homing, QGL or Bed mesh probing I get an error: "Communication timeout during homing probe" Checked the cabeling, checked the termination resistance, checked all the CAN related stuff. Nothing. Started to google around a lot and...

So, Stealthburner build. For the Stealthburner I will go with Bondtech LGX Lite Pro Slice Engineering Mosquito hotend Slice Engineering PT1000 500 degrees temp sensor Slice Engineering Mosquito 2v 50W heater Bondtech CHT nozzle Chaoticlabs CNC Tap V2 Fysetc SB CAN Toolhead All parts are...

Ok, so as the Toolhead board was delaying the project, Goldie just sat on the bench without any attention until New Year. I then had to update the computer and Spider Board with newer versions of Klipper. Found an oddie, that CANBoot didn't put the board in boot mode, I couldn't understand why...

The CAN bus toolhead is on its way, but seems to end up around May 12-17, so I had to change my plans. Installed the Toolhead PCB and the cable in a umbilical setup, running through the vent in the rear. So did the last part of the initial startup - rotation distance and attached the panels and...

This is my bed. Bed at 100C, for around 20 min before bed level. EDIT: Oh, without any panels...

Fysetc has reconised the error and is sending me the Toolhead board. However, Aliexpress says it still not sent... damn, I haven't installed the umbilical chain as I intend to put the CANBUS cable differently so I am hesitating to continue with the first test print. So instead I have finalised...

Yes, that was my thought too... either it is a very tiny airpocket or irregularity in magnetic sheet. Because the irregularity is so strange. Like, not the edges but a top in one spot. Will see if I can take a picture when at home to show.

Haha... that looks a lot like mine. :) But I have around 0.1 in flatness though. Did several mesh measurements starting with different bed temperatures from room temprature to 100C and it had basically the same shape. Didn't change much. As it stays around 0.08-0.1 and next step in my...

Yea, got it. (y)

Ok, interesting. But you don't have any connector in between the printer space and outside, instead the cable is running straight through and down to the electronics bay? I was thinking if I should attach a connector for the cableing inside so it is easy to remove and re-attach when ever that is...

I am curious on how you have wired the cable. I will not use the cable chain on my X-Y axis and want a nice solution so the CANbus cable can move freely but controlled. :) How have you done?

Fired up Fusion360 and created this simple bracket that mounts on top of the pcb din clip from the Voron STLs. And this is how it was fitted in on the printer.

Yes! A package arrived in the mail. 🥳 but noooo, they missed to include the toolhead in the package. 😪 But no shame on Fysetc. Actually I start to like them. As said before, I get the feeling they want to be perceived as a serious player and feel they start to live up to it. Remember...