Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members!
Nice putting the code in Cura worked. Thanks
I noticed I dont have a seperate start_config.cfg file I believe its is built into the printer.cfg. Should I break that stuff out? or does it not really matter. I did make a seperate one out for purge.cfg.
I would like to use Cura 5.3.0 since I have to for my other printer. I added Tap and Prusa works great with it, heats up bed and nozle to 150 then taps and after continues with the print.
Cura heats up the nozzle to print temp and trys to melt the bed. Anyone have a clue what I may need to...
you are correct, I found it last night. My sensor is on the board and is very fussy, I will reprint the part that goes into it and add a little more material to it.
Thanks for getting back with me, I greatly appreciated
I just bult the Voron 2.4R2 Version C LDO kit. I may have done bad and went straight to trying TAP. The Tap kit I bought from MH with the pre-made wire with the resistor on it. I checked the polarity and red goes to 24 V Black goes to Gnd and white is in the center pin On the Toolhead board...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.