Recent content by RNLauritsen

I'm about to start building a Voron 2.4, after i got around to assemble my moded Sunlu S8 again, but it takes up so much space, due to the print bed, and 310x310x400 is nice, but im not going to use that much print area anyway, so i decided to go with a 250 build for my 2.4, since it fits my...

so my friend was asking around at his job, they think that they got them from RS PRO, but they are not sure, i tried finding them on their website, but it does not appear to be there, so i think it is a discontinued product perhaps, but short anwser, properpblyh RS PRO

i have asked him today, and he will try and see if he can find it out

FINALY! it´s alive :D and it even managed to print the first test print without any trouble, the only thing there is left, is to finalise the enclorsure thats going on the back, where all the electronics can reside, kinda like a mini PLC cabinet (and clean up some of the wiring)

i had the same problem with my skr mini e3 2.0, i followed the official voron guide, and i had forgotten to follow "Ensure that “GPIO pins to set at micro-controller startup” includes ‘!PA14’", even though i fought i had read everything there, but apparently not, maybe it might help you out, it...

I almost forgot it, i also managed to install Klipper on my Raspberry Pi, and connected the Elegoo TFT touchscreen via the GPIO pins, the colours are dim, the viewing angles are bad, no to speak of the abselutly high refresh rate, of just 4Hz, but it was cheap, 5£ on sale from amazon (DE), and...

Well, after a long time trying to find a bed, that was cheap enough for me to buy, i simply just gave up, and decided to make one myself. One day, i was talking to one of my friend, and he happened to have some cast aluminum sheet laying around that i could have, since he where going to scrap...

I think it is a shame, that no company is selling coloured GT2 belts, now that's something that would look super cool for customisation, since all accent colours could match the belts in some capacity

I got them from a friend who works with automation and robotics, these are fiberglass reinforced, I got no idea where the place he works at got them from, but I won't complain, free is free after all 😅

Running the belts was actually quite easy, I thought it would have been a bigger struggle then what it actually was. And with the toolhead in place, it is starting to look like a 3d printer

After an eternity later, have I managed to cole this far, one this I need to figure out, is how I am going to attach some kind of rubber feet to it, since the feets I have attached, was a mod that should help with the high if the z motor, but it is just tall enough, so it stands on the motor itself

So far so good, reminds me of a small Ikea Eket at this stange

Thanks 😁 I know that 3DE premium PBT+ snow white is a great material, even though that is white compared to the black variant they sell, but I do think it is because of how the PBT behaves, and the added glass fibre, except that you can't print really fast with it, like abs, since it doesn't...

oh, and by the way, the reason that i gave this (soon to be) voron the nickname "the egg" is because, i always thought that the voron v0.1 looked like an egg, and this is going to white, so, well, i thought it was fitting

Short about me, i have been 3d printing since 2011 with a RepRap Mendal (i got the printed parts from a guy i knew who at a university in Copenhagen). Then i upgraded to a printbot plus (the wood model) back in 2015, who i replaced with a modded sunlu s8 in 2021, but had to take it apart in...