What's new
VORON Design

Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members!

Recent content by RobAndroid

  1. R

    Cartographer initial Setup problem

    Thank you i resolved it. I had to delete This part #*# DO NOT EDIT THIS BLOCK OR BELOW. The contents are auto-generated.. Now it works
  2. R

    Cartographer initial Setup problem

    Thanks i am now at the point, that i have my z offset but it does not home. It says "No cartographer model loaded" i was going through the calibration process. Thats my save for the model #*# DO NOT EDIT THIS BLOCK OR BELOW. The contents are auto-generated. #*##*# #*# [cartographer model...
  3. R

    Cartographer initial Setup problem

    Thank you very much. I now do have a z-offset = -3.930. Position of my toolhead now says x= 150 y = 150 z= 434,000 although it is right above the print plate. Endstop Z still triggered after going through calibration process and the SAVE_CONFIG Prompt. Homing z fails into the error that the...
  4. R

    Cartographer initial Setup problem

    Hello everyone. I have a question. I have installed the Cartographer on my Voron 2.4. First i had a problem the sensorless homing issue for X/Y. I start the process as described with G28 X Y. Then I have to enter G90 and start with G0 X150 Y150. Next I start CARTOGRAPHER_CALIBRATE. It shows me z...
See more
Top