VORON Design
Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members!
Recent content by S24
-
S
Rough Faces on Print
When I turned the cooling off it helped a lot but there’s still a little bit of the bumps still forming. What do you think?- S24
- Post #4
- Forum: Slice and Print
-
S
Rough Faces on Print
Cooling was at 100%. I tried lowing it to see if that makes a difference. I will see if anything changes and let you know.- S24
- Post #3
- Forum: Slice and Print
-
S
Rough Faces on Print
Hello, I have a Voron 2.4 350mm 3-D printer, I am currently working on a project that involves needing smooth surfaces. Would anyone have an idea of what this issue may be? I am currently printing my prints at 275mm/s and my extrusion rate is at 22mm/s^3 or 9.15mm/s. I’m thinking the issue has...- S24
- Thread
- Replies: 3
- Forum: Slice and Print
-
S
ABS Experimenting
I recently built a Voron V2.4R2 and have my 0.4mm nozzle on my printer. I have been printing PLA 1.75mm with no issues however, I want to try to start experimenting with ABS 1.75mm. Will there be any issues when it comes to extruding the ABS filament? Do I have to worry about any excess PLA...