Recent content by Scytes

Apologies I was just thinking I forgot to post my solution to the issue! I started from base firmware - updated all my axis directions so they were all the correct direction when buzzing the steppers. That revealed two issues to me: A belt had slipped off the idler pulley and was causing...

I'm sorry I should've specified - that is what the homing points SHOULD be and what I'm expecting. What is happening is X will move correctly but Y will move to the front. If I swap the pin direction for Y in the config it does the opposite - X goes left and Y goes back. Same situation if I...

Correct - with Stepper X =B, Stepper Y = A, the homing is to the right on Stepper X and to the back on Stepper Y. If I swap A and B on the board they home perfectly, albeit it X is going to Y and Y is going to X - it's only when we have them connected correctly on the board do they act strange...

Good morning, as the title suggests I've got an odd issue. If we SWAP motors A/B on the board so that they are wired with A to motor 0 and B to motor 1 the x and y home and move in the correct direction. However the two axis are inverted this way (X is front to back while y is now right to...