Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members!
I found it, There are several versions of the BTT Octopus V1 thru v1.1 and the Octopus Pro V1.0 V1.0.1 and V1.1 429 and 424 (I think) however mine is the STM723. All documenttation is for the other two and the other versions.........I went back and searched just for the 723 and found the one pin...
Strangest thing. I have everything going great for my belted Z on my new scratch built Trident. the only problem is when I get to the part of the homing Z the bed goes up and hits the endstop. There is pauses a second, then it goes up more. The only difference between this one and the standard...
According to all the linux and like groups, these usb 2.0 cameras have caused alot of issues and errors and there are some with work arounds but no real fixes.
Ok, so now I know what happened. I have everything up and working again flawlessly. It is totally amazing and so simple. I never tied it to a event that happened some time ago and to some really weird events during prints.
So the simple was my webcam plugged into the pi4. Yep it was causing...
Well sorta did that already. Like in the first post the Voron Cube and the Benchy printed fine. I did a couple of others and they printed fine. Just a few of the STL's I have been trying since the motor change and recalibrations are messing with the print. Those STL's are doing the same thing...
I checked the grub screws and belt tension 3 times when I re-calibrated after each crash. When I say crash that what it is. You hear and see the tool head driven into the bed by the steppers. I am trying cura today to see if it is something that orca started doing when slicing.
I replaced the...
I finished my switchwire a few weeks ago. I have about 80 hours of printing without problems. I was using cura but switched to orca about 30 print hours ago. Still no problems.
I had a stepper problem, replaced 2 of them. Did all my test and calibrations again, printed the voron tets cube v.7...
About normal for belt tension. I have tried replacing steppers, drivers, different sensitivity settings different slots on the board including E0 and E1 and X is just behaving badly for homing. So instead of fighting it any longer I just put in a end stop and moving on. Took 10 minutes and...
I have something weird happening. My switchwire is using a skr 1.4 turbo, 12vdc, sensor-less homing on X and Y with a probe on Z, other than that its normal. I just finished it and did the setup. I have one thing that is not working quite right. When I home I have to do one axis at a time. When...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.