Recent content by Slewfoot

Another thing that isn't listed - broken belt. I had one of my belts break internally and only caused issues when I printed in certain areas of my bed. I guess this could be related to belt tension, but I wanted to make a point of it as it happened to me and I was pretty frustrated with it for a...

I use a flexible PEI build sheet for ABS. It's usually smooth PEI, but depending on the project, I sometime switch to the textured build sheet. Occasionally I scuff up the smooth PEI it up with some fine steel wool. I only use Aqua Net if I'm printing PLA.

Hmm. I’m running 84 of them without any issues. Not sure what the limit is, but I don’t have any issues at 84. The power is connected directly to the power supply, so no issues there either. I’ve got it making pretty blue comet effects without a hiccup.

Why add another PCB when all you need is a data pin? I just use the I2C data pin and assign it in Klipper.

If you are planning on installing case lights, I would recommend printing and installing these... 5v LED Strip LED Strip Holder It's pretty simple to wire them in. just grab power from your 5v supply and find a spare data pin for the signal line. I just finished doing a complete re-wire and...