Recent content by Slightwave

A small report about the long way to eliminate this problem, maybe it will be useful for someone. Here is everything I tried and it does not work: 32 bit linux, 512000 kb CANBUS speed, glued jacks on all connections Buying super expensive shielded cables for HIFI sound All this is a bunch of...

Thank you very much. "Ignore the 4 pin Max13864 header right next to it" Yes, that's exactly where I got confused. I need to plug it into a completely different jack. Thank you so much. It works.

I have already broken my head and can not understand anything with this ATC Semitec 104NT-4-R025H42G. Can someone throw a picture or a diagram of how exactly it should be connected to the 2240 and what should be specified in the config? all over the internet only some fragments of information, I...

Searching on forums I found an interesting idea that the problem may be in the 64 bit operating system and compatibility with the Mainsail. By default bigtreatech uses 64bit in its images.... I'll probably try to install 32 bit first, and then I'll worry about the CAN board.... Somehow it seems...

Everything is flashed to 1,000,000 according to the guide... OK, I'll try flashing to 500 000. Thank you. Is it possible to change only the EBB and leave the MCU as it is, or is it necessary to have all devices running at the same speed?

Uh, yeah, sure. Here. Thank you very much.

No, the problem's still there. Tonight the printing just stopped in the middle of the process. I don't know where to look. 99% of the time everything works but sometimes this happens. I can't find a pattern yet.

It seems that the problem was with the BTT PI, I replaced it with a new version with memory on the board, and everything works as it should.

This is my first Voron, I'm not sure about anything, but it worked for a while, I've printed a small number of items, it's very hard for me to understand what exactly is not working here. Also, the Tmc 2240 works via SPI and the sensitivity there is set very roughly due to the range of available...

Recently, I built my Voron 2.4. Initially, everything was running smoothly. Then, I decided to switch to sensorless homing. I thought I set everything up correctly, and it seemed to work, but that's when the problems started. First, the printer stopped booting. Considering we have frequent power...