Recent content by Sohrab

I recently tested a good way to stick abs on glass bed: I am using Glass frosting sticker with 70 degree celcius bed tempetature with excellent result😍

There is a video on youtube about native adaptive bed mesh showing process but at the end there is something you shoud do: 1- in stepper z adjust z end stop offset. 2- in probe, adjust z offset for probe. be carefull, go from 0 to about 6.0 in 1mm steps and check adaptive bed mesh while...

I put some tissue where there is holes+ a printed rectangle added to klicky base to ban airflow downward.

Is it normal?

This airflow has a bad effect on ABS, where I need Zero airflow for first 5 layers. It is my main problem, impacts print success and I am trying to get rid of it, have you found a quick way?

Hi, try 110% extrision on top layers, 120% for first layer, Says gpt.

Humm, I have build a 450x450 and going to test for input shaper tomorrow, God bless me😨😬

Hi , I have build a 450x450x400 Voron 2.4 r2 and tomorow I'm going to calibrate it, I hope it would work fine😍 if so I would like to request for serial number.