Recent content by staticanime

I use GitWatch to automatically upload my printer_config folder to GitHub any time I make changes. Bit fiddly to set up, but once it's work, it's been set it and forget it

This guide should be of some help: https://github.com/maz0r/klipper_canbus/blob/main/index.md Based on the diagram there, the U2C is your CAN Controller, the Octopus is the Printer Controller, and the EBB is the CAN Toolhead So, connect the U2C to the Pi over USB, and set up the can network...

I've had very good experience with PolyMaker's PolyLite ABS, printed my 2.4 parts on an Ender 3 in a box, using the Grey and Teal spools, and they were flawless. The Ender 3 was then "upgraded" to a Switchwire with DarkDog's mod, this time with Black and Orange PolyMaker ABS & Filoalfa's Azure...

Do you by any chance have a picture of *how* tight yours is, mines flush with the outer Clockwork body, I really don't think there's enough room for cabling+connector?

Printy Please has the Z Motor brakes available, considering it for my Switchwire: https://www.printyplease.uk/zbrake