VORON Design

Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members!

Recent content by Stucarius

  1. S

    What have I done wrong

    I thought I set up sensorless for all end stops but I gave up on that and went ahead with Eddy for Z endstop and physical triggers for X and Y. When I turn on the machine and boot up Klipper I am still getting X:triggered Y:triggered Z:open.....Whats up?
  2. S

    New 2.4 r2 will not home

    I have a new build 2.4 r2 with a Eddy sensor I am trying to use for sensorless homing. When I query_endstops I get X and Y Triggered and Z open. I have buzzed all steppers and they are connected and apparently running correctly. When I try to move the print head I am told to home first. It will...
  3. S

    What have I done wrong

    OK I ran another query and I got this: x:TRIGGERED y:TRIGGERED z:open
  4. S

    What have I done wrong

    I wrote an earlier reply but apparently the forum software did not post the reply. Do you have any thoughts on what might be wrong? I am inclined to remake the printer.cfg file and see if that helps.
  5. S

    What have I done wrong

    Do you have any idea as to what is wrong? I am currently inclined to completly rebuild the printer.cfg file.
  6. S

    What have I done wrong

    I don’t have physical endstops. I’m using the Eddy for that. Could that be the problem?
  7. S

    What have I done wrong

    So far as I can tell it does nothing when I enter it.
  8. S

    What have I done wrong

    Also if it helps. The Z axis does not hold position. It just slowly falls to the bed. The steppers are all getting signal. I know that because they will buzz and rotate back and forth a few steps.
  9. S

    What have I done wrong

    What I get is a statement "Must home axis first: 1.000 0.000 0.000 [100.000]" When I click the X Axis movement button or enter it in console. I get the same response for each Axis. Is that what you wanted to know?
  10. S

    What have I done wrong

    Is it possible that the axis have been placed in a "parked" status somehow?
  11. S

    What have I done wrong

    Silly answer…I don’t know. I do not have physical end stops. I am supposed to be using my Eddy for endstops.
  12. S

    What have I done wrong

    I am relatively new to Klipper. I cannot make heads nor tails of the log. The only thing I did notice is that MCU S03 loaded but I did not see anything else load.
  13. S

    What have I done wrong

    Here is the Klippy Log
  14. S

    What have I done wrong

    Sure. I’ll post it up in the morning. Thanks for helping. Do you have any thoughts after seeing my printer config file?
  15. S

    What have I done wrong

    I've been trying but when I put in the command or click home I get nothing. If it were not for my successfully buzzing the steppers I would think they were not hooked up. I uploaded my printer.cfg
Top