Recent content by ted223

Thanks, that is what I was looking for!

My mistake, it's the stealthburner I have.

Is there a STL available that will work with the orbital 2.0 and TAP? My current setup is the stealburner + TAP.

My kit didn't come with one and being new to Voron, I wanted to get what I have working first.

That did it. The plug supplied with the tap kit was not in the correct order. I swapped sig and ground on the plug that goes into the sensor. Many thanks!!

I fallowed Nero3d on configing the TAP and already made the printer cfg changes before posting here. The black signal wire is going to PG15 and uncommitted that under Probe in the config. The results are the same. I then removed the sensor and used dark colored needle file handle to test the...

I am having the same problem. I hooked up the TAP sensor the same way as the hall effect sensor as outlined in the manual that came with my formbot 2.4 r2 kit. Mine stays triggered in both positions, How would I define the probe in the printer config?

I got neopixles working. I forgot to add [include "file name.cfg"] in my printer config. Now woking on TAP.

I have it hooked up with the diode as outlined in the manual. Could you share your config? Mine stays triggered in both the up and down position. I do have the neopixles hooked up to PBO. I will check the polarity.

I put together my first Voron kit and have everything working except for TAP and the neopixle lights. My kit came with the BTT Octopus v1.1. How is the TAP suppose to be wired into Octopus?