VORON Design
Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members!
Recent content by thaug52
-
T
Nitehawk-SB setup PT1000 and Filament sensor
I was able to resolve the PT1000 issue by setting the pullup_resistor to 2200. There is conflicting directions for setting this between the Nitehawk (2200) and the Leviathan (4700).- thaug52
- Post #2
- Forum: Electronics
-
T
Nitehawk-SB setup PT1000 and Filament sensor
I am new to Klipper (but not RRF and Marlin), I am trying to set up a Voron 2.4 LDO kit with Leviathan V1.2 and Nitehawk-SB. My Rapido hotend has a PT1000 thermistor and when I set it up in the printer.conf with Pullup of 4700 it read 350 degrees in Mainsail when at room temp. Will the PT1000...- thaug52
- Thread
- Replies: 1
- Forum: Electronics