Recent content by Timmyklus

So I had some extra idlers. Guessing they were from the same batch as what was previously installed. Put the new ones in and set belt tension per the freq Instructions, it seems a little better. I ordered some new idlers from west3D, once those show up, I’ll swap those, retention and redo my...

I checked the defect spacing and sure enough, it is 2mm! What about the idler would cause this? Guessing it would only be the toothed pulley? And not the smooth idler behind the toothed.

Hey all, Just completed building my voron with the help of a buddy. (He built most of it) he has built 5 machines so far. The issue I’m having is in the X axis, I am getting a very faint vibration indicated on the print surface. The Y axis is super smooth. If I rotate the part at a 45 degree...