Recent content by Timvoron2.4

Klipper shows open never seen it any other way whatever I do. Should I lower the voltage set on 24v at the moment. Sorry about the confusion on the picture with no jumper I took that earlier just to show the tool head I was using.

picture of wiring and jumper

Hi The "npn" jumper was installed wrote it somewhere in the first part of the question

Hi thank you for answering I have attached a photo of the stealthburner tool head

I have tried to reload the btt pi firmware more than once as was suggested, attached the klipperscreen log and picture of screen. Tried several different cables. Reloaded klipperscreen kiauh several times Please help spent a lot of hrs on this problem

New build voron 2.4 v2. 350 with btt canbus 2209. The omron TL-Q5MC2-Z does not seem to work correctly the indicator light comes on when powered up put a metal ruler near the sensor the light goes out which i believe is the wrong way around, I have swapped the blue and black wires no difference...

Thank you all I have found the uuid number by starting all again also removing the C cable and using the canbus cable at the end, think I have it fixed now maybe.

Hi thanks for answering, I did flash again but as it has been initialized the uuid is not showing

Hi very new to Voron as you can see Voron 2.4 r2 Formbot kit with canbus btt 2209/2240 octopus 1.1 u2c and btt pi When programming the tool head i missed the canbus Uuid number, But having read all the info I can find because it has been initialized i will not be able to find it. Is the any way...