Recent content by Velychkin

For now, I don't exceed recommended values for print moves. But for travel I use 7k accelerations as a final step to eliminate stringing with PETG (yes, I know about drying filament, retraction calibration, pressure advance calibration, disabling z-hop, etc - all of it is already done). Do you...

My linear rails doesn't have lubing ports. Is there any way to lube them (as regular maintenance routine) without disassembling whole gantry? I've used Mobil EP2 (by removing carriage from rail) when assembled first time an relubed rails when was upgrading to MGN12.

I've got Voron 2.4 300. Input shaper recommendations are nearly 9k on X axis and 4.5 on Y axis. Max accelerations according to ellis3dp guide is 30k. Is it OK to use accelerations higher than 4.5k (for example 10-15k) for travel moves, infill or even inner walls?