Recent content by Voron2.4Started2023

OK, Problems Solved. I replaced the belts with a different set. And when I took the first set off and checked them for missing teeth and to feel if they were stretched. And yes I have a 100mm length that was stretched enough to feel a difference. Im not sure if it came like that or if it was me...

Yes, I've set the home in the printer.cfg in the [safe_z_home] home_xy_position:237,350. and yes its the endstop pin, Its a formbot kit everything so far from the kit has been fine and I have seen others with the same problem. Here is the Start_Print Macro [gcode_macro PRINT_START] # Use...

So I'm a newbie for building printers. I've been Printing for about 7 years but the Voron 2.4 is the first printer I've built. Everything is finished and basic tuning is done, I've got a couple of test prints done (Voron Cube which comes out great). But I've noticed that the Z position on the...