VORON Design

Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members!

Recent content by VoronManiac

  1. V

    Max Bed Power Limit with Under Bed Fans - Urban Legend?

    @shiftingtech -Thanks for the sanity check! Sounds like there should be a footnote/update to the Ellis article. But people are still using those Klipper macros? "2. the power needed to actually warp an aluminum plate is bananas" - that's what I would expect as well, but couldn't find any...
  2. V

    Max Bed Power Limit with Under Bed Fans - Urban Legend?

    In Voron User Mods this thoughtful article by Ellis talks about under bed fans and limiting power density to 0.4 watts per cm^2, imposing a limit of ~48% of max power for his setup. This causes painfully slow chamber heating times. I remember seeing similar references to limiting bed power...
  3. V

    3d printers bay kits?

    i've purchased three (pre-TAP) 350 2.4 Formbot kits from 3D Printers Bay over as many years. Also printed parts sets for two friends who also went thru 3D Printers Bay (last was built as a TAP). Each of the kits was a little bit different as Formbot seems to be trying to keep up the latest...
  4. V

    non-Voron question for experts

    DanPin - I 100% agree with vinnycordeiro's answer to your question, but are you asking the correct question? I think many people build a Voron printer for the adventure of it, rather than just buying an off the shelf unit. Lots of evolution, mods and customization's. One of the roles for a...
Top