Recent content by Weazel14

Did you try ellis printing guide for setting up superslicer with the correct start gcode?

Thank you all for the help. I now have tap temp set to 150 and bed to temp before doing my start routines, also after probing and before purging I have it hotend heating to temp then purge and print. Thank you all again for the help. I have had a little experience with klipper not much but...

I will try the 3 lines from Ellis guide pages for superslicer and see if that works when I finish up my print I started. I will let you know what happens. Thank you.

I also installed the btt ebb sb2209 kit for canbus. Here is my whole printer.cfg and for the KAMP.cfg i used all the standard files for all .cfg files in the KAMP github.

I just built my first voron 2.4 r2 using the formbot kit. I immediately upgraded to Tap and installed KAMP. I started using superslicer and I can get the adaptive mesh running but when I try the Voron_Purge or Line_purge.cfg I get the dreaded error of not being able to extrude because I am...