Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members!
one mere thing to check ..... I'm sure you did set this up correctly but just in case you did the same mistake as I did ... make sure to set your X and Y offset to 0 in the probe section .. I forgot that step and my measurement wasn't correct as I had y_offset: 10 ( from previous probe )
Here is...
hmmm.... when I was working on my TAP I paid attentions for the magnets and was looking specifically for the N52 not the cheap ones on Amazon - so I bought them from the store which specialize in this kind of stuff .... so I know it's 100% accordingly to the specs. but ... from time to time have...
You do not need check / adjust Z-offset every print or every time when you are replacing changing bed sheet because with TAP your nozzle is your probe . You just need to do first time calibration ... however, you have to remember that some small particles or simple ooze might affect your...
I just imported Standard one to my PS 2.6.1 version and testing ... increased little bit speed ... so far I got much better quality and faster prints than I got from my tests from SS and OrcaSlicer 1.8 .... I'm supper happy so far !
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.