Recent content by Westy-nz

I went down the rabbit hole of self source building and got 3 hours in and price was getting closer and closer to the kit suppliers. I sat back and thought .... "You now what? ... how much is my time worth?" ... "This is ridiculous - just but a kit at least you know all the parts are there and...

Should not be able to slip. has the 115 bearing on the other side for one side of the filament and the drive side it forced through the motor drive gear with the filament drive teeth on it. only thin I can think of is if the drive gear was not seated correctly when installed and locked up and...

Welcome! - Yes I agree with the other comments here, you probably need to work through it yourself. I personally built a 2.4-R2 350 with canbus and Tap. I went for the 350 because I know that it would be the only printer I would be allowed (one) so thought, it would suit all of my needs for now...

You could see if it propagates into another slicer. Try Super slicer for example and see if you get the same results. or do a fresh basic config in cura and see if that works.

9.5 times out of ten is is the incorrect Z offset set. - I have found with mine anyway. I am running a Tap ... so use probe_calibrate. I use a 0.1mm feeler blade and set it that way with the GUI baby steps. then save_config and that saves the offset. I have a filament sheet which has notches...

I have just built my first Voron 2.4 350 R2 with Canbus and CNC Tap Z-homing. I am so happy that I went for the 350. I bought my kit from Magic Phoenix (minus the functional ABS Prints) - Got my Prints directly off the PIF program and am sooo happy and proud over what I ended up with.