Recent content by wilsgarc

I could be wrong but Voron tool changer builds use a shuttle along with nozzel probe for z-endstop and gantry leveling i've also seen videos of voron builds using nozzle probe without additional probes ... i think ive done some searching and read that tool changers use Tap sensor and use...

Just finished my 350mm build when it comes to quad leveling info .. could not find a decent tutorial/guide on how to set it up and running it on klipper so far I've kinda pieced together this but not sure if im right quad_gantry_level] gantry_corners: -60,-10 410,420 points...

yes .. thank you

A while a go a can across a project involving flat coil steel spring cable used for umbilical cable clips ( canbus) for wire management [Constant Force Springs Flat Spiral Coil(0.3x3x2160mm) ] did the smart thing and forgot to bookmark the page most of the ones at the moment use music...