Recent content by Yeri

Thanks for the info! I agree, a small amount of movement is not going to be a problem, it will be absorbed by the pom nuts moving around.

Very interesting, I’ve been tracking instances of this happening and trying to find any correlations. With the bottom screws either not in or not completely tightened, the leadscrew remains straight? Also, if you could test moving the bed up and down once it’s all assembled like that, and see...

Wrote an email to the support address listed in the phaetus site, that bounced immediately. Not super impressed with that. My last attempt at a fix didn’t stay, so I will use some wire to strap this thing into place

Klipper by itself doesn't have a macro built in, but the default voron configs have a very basic print_start embedded toward the bottom of the printer.cfg file

I've had genuine BLTouch melt in an unenclosed ender 5, I think even the bed heat is enough to make those unhappy. If that's the case, I wouldn't trust something only rated to 60c, when there are several alternatives commonly available (inductive, klicky, tap)

Post-holiday progress pics Got the towhead put together, this is a stealth burner of course :) I ran into an issue with the DropEffect XG hotted though, the thermistor is secured in a little brass support with some form of ceramic compound, but mine completely disintegrated. I saw a bunch of...

I love fusion filaments, while the color selection is rather small compared to some other manufacturers, the spool to spool consistency has been spot on, no issues. Their high-sparkle filaments are fantastic to see, and print really cleanly. I only have one issue with fusion, and that is I...

I picked up a few spools cheap on amazon for a test, I use these as my prototyping filament since they print pretty consistently. I've seen a few places where there are cooling issues, so you may want to up the fan speed a bit on these, but I haven't done a full and proper filament tune on this.

I generally like KVP, and I love their wide variety of colors, they have shades that I can't find anywhere else, including a really nice British Racing Green. Prints very consistently and I haven't had issues with them. However, all of the spools I have are from before their infamous...

Depending on what parts you are keeping vs replacing it looks like it might work

Build is still progressing, been on vacation so it paused a bit. Working on the toolhead, but need to order a fan since I will be putting mini-sb on it instead of mini-ab. Once that gets in I’ll get that all sorted out. In the mean time, belts have been run, and I decided this one will use...

Just anecdotal evidence, but it seems like every person I’ve conversed with that has both a v2 and a trident prefer the trident. Nothing wrong with a v2 either, just trident is a more straightforward build

Got the Z motion, motors and idlers all built. Starting to look like a printer! I included a detail photo of the rear Z extrusion, this shows how it's intended to look. It does not center on the horizontal extrusion above it, and there should be about a 1mm gap between the two as well...

When you realize you forgot to print some parts... Good thing I've got a handy salad fork available :) Also no fear with a lot of small parts!

I kept the X endstop on the toolhead for my setups, although sensorless would also be a viable option