Ho-whizzle
Well-known member
Hello all.
This is a long one so i will try to make short and to the point.
I have made the move to Fluidd as it a like version of Mainsail as I have an issue with my LDO Nitehawk which is ongoing (link to other post below).
After setting the Fluidd and setting the config file I cannot get the printer.cfg file to my MCU as when i use the "ls /dev/serial/by-id/" I get 2 IDs and I dont know which one to use. I have read through both the klipper and Nitehawk installation guide but I am stuck on getting them communicating with each other.
Now I am super confused (T_T) and coming here for some help and advice.
Thank you all in advance.
This is a long one so i will try to make short and to the point.
I have made the move to Fluidd as it a like version of Mainsail as I have an issue with my LDO Nitehawk which is ongoing (link to other post below).
After setting the Fluidd and setting the config file I cannot get the printer.cfg file to my MCU as when i use the "ls /dev/serial/by-id/" I get 2 IDs and I dont know which one to use. I have read through both the klipper and Nitehawk installation guide but I am stuck on getting them communicating with each other.
Now I am super confused (T_T) and coming here for some help and advice.
Thank you all in advance.
