Toolchanger xol with tap

[orge]

Hi
I am looking for toolchanger preferable based on xol and tap ebb36
Where domi find stl, documentation for this ?
Newbee in toolchanger
Brgds

 

[Maas101]

You don't say what printer you have. If it's a 2.4 then Stealthchanger is probably the most popular tool change system and supports XOL https://github.com/DraftShift/StealthChanger . If you have a Trident or other fixed gantry printer then it becomes a bit more complex. You can use Stealthchanger with a lift bar or the MadMax changer may be better suited https://github.com/zruncho3d/madmax/tree/main

 

[orge]

You don't say what printer you have. If it's a 2.4 then Stealthchanger is probably the most popular tool change system and supports XOL https://github.com/DraftShift/StealthChanger . If you have a Trident or other fixed gantry printer then it becomes a bit more complex. You can use Stealthchanger with a lift bar or the MadMax changer may be better suited https://github.com/zruncho3d/madmax/tree/main

It is a 2.4R

 

[orge]

I am going with the stealth changer, but cannot see where the tap should be, any usefull links ?

 

[Maas101]

Not sure I understand the question, on stealthchanger the tap functionality is built into each toolhead. Each head has an opto sensor in it which when docked onto the carriage allows for the 'tap' to be registered, pushing the head further up releases it which is how docking works. The stealthchanger github I linked to earlier has a full build guide.

 

[orge]

Not sure I understand the question, on stealthchanger the tap functionality is built into each toolhead. Each head has an opto sensor in it which when docked onto the carriage allows for the 'tap' to be registered, pushing the head further up releases it which is how docking works. The stealthchanger github I linked to earlier has a full build guide.

Ok, cannot see it, but maybe as the build come along it gives meaning thanks. The tap i use for the height adjustment is the one i am looking for

 

[Maas101]

Z height? Yes that's it. Its built into each toolhead. This gif shows best how it works motion the circuit board on the right attached to the toolhead is the opto sensor

 

[orge]

Sorry for all the dumb questions.
I cannot find the dock stl where the idle toolhead is placed.

 

[Maas101]

GitHub - DraftShift/ModularDock: Modular Dock for StealthChanger

Modular Dock for StealthChanger. Contribute to DraftShift/ModularDock development by creating an account on GitHub.

github.com

 

[orge]

GitHub - DraftShift/ModularDock: Modular Dock for StealthChanger

Modular Dock for StealthChanger. Contribute to DraftShift/ModularDock development by creating an account on GitHub.

github.com

Your are a champ