I could be wrong but Voron tool changer builds use a shuttle along with nozzel probe for z-endstop and gantry leveling
i've also seen videos of voron builds using nozzle probe without additional probes ... i think
ive done some searching and read that tool changers use Tap sensor and use the toolhead nozzel as the bed probe
but haven't been able to find guides on how to configure
if anyone if familiar with method can you point me in the right direction ?
i've also seen videos of voron builds using nozzle probe without additional probes ... i think
ive done some searching and read that tool changers use Tap sensor and use the toolhead nozzel as the bed probe
but haven't been able to find guides on how to configure
if anyone if familiar with method can you point me in the right direction ?
