- Printer Model
- Voron 2.4 self sourced
- Extruder Type
- Clockwork 2
- Cooling Type
- Stealthburner
My voron 2.4 has been working for years without many issues. Recently I started a print without changing anything, not even turning it off and on and the thing crashed while homing. The B stepper stopped moving and made terrible rattling sounds like one of the coils disconnected. The wiring is all fine, I measured the resistance of the coils and the wire and its a very stable 2 ohms on each coil. It is intermittent, like currently it just does terrible layer shifts. I am using a spider 2.2 board and the thing has a stepper driver overheating issues, using tmc2209 drivers with the heatsinks installed properly. Like if I let it sit at hold current without the fans on it will overheat in 30 minutes. I already made a post on r/VORONDesign but I didnt get any answers.
