Recent content by AwDuck

Pah! I had sent some (impressively!!) quick z moves through in the console and my printer kinda smirked as it complied, but I didn't think of acceleration causing this, especially since I haven't messed with the acceleration in the slicer that I know of. The Z accel is the same in the config...

I did vibra-tite on everything that threaded into metal, though mine was going to have to make a heck of a transit once assembled, but I don't think it could hurt for the average Joe to use it either.

I can't seem to figure out where I've gone wrong. My z axis won't go up, but only while printing. It homes as expected, I can manually (via web/front panel) move it up and down, and there seems to be no rubbing anywhere. It's like it's stuck on the same layer but only when printing. It's...