Recent content by Barrisen

i have tried looking at the gcode and cant really see anything weird in it. but im no expert by any means. When looking at the "live" Z value in the mainsail dashboard when printing it does not seem to be creeping up. all the software for the printer is updated, and im starting to think about...

i've gone through ellis print tuning guide. re did flowrate and preassure advance now when i installed orca. i have started to suspect the bed mesh might be doing something but i can first try disabling it on Monday to see if there is any difference. im using a brass 0.4mm nozzle and 0.2mm...

I have now tried using Orca slicer aswell and am getting the same issue. so it doesent seem to be slicer related

Hi, Im having some issues on my fist and second layer where edges and center seems to be printing at a good height but the infill seems to be going further and further away from the buildplate. When the second layer starts it seems to be prinitng to far away from where the first layer got put...

I found the issue, one of the cables for the thermistor on the x carriage had started to break. Thanks for the assistance!

Yes, have tried to retune the extruder a few times

Is seems to get worse the loger it is running.

Hi, im having some issues with the hotend temperature stability like in the attached photo. I have tried changing the thermistor but it made no differance. it has been working about 500hrs before this. What could be the issue?