VORON Design
Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members!
Recent content by Breaker1066
-
Question Alternative XY endstop mounting bracket
Do you have a link to this design by any chance?- Breaker1066
- Post #8
- Forum: Voron V2.X
-
BigTreeTech SB2209 CAN Bus Expansion Board with Rapido 2 hf hotend not compatible?
There is a two-pin TH0 connector next to the PT100/1000 connector. Just make sure you have the correct pin and thermistor type specified in your printer.cfg. You don't need to touch the PT1000 switches at all. I think the Mellow boards do share the same connector for thermistors and...- Breaker1066
- Post #4
- Forum: General Voron Chat
-
Formbot
My experience is with a 2.4r1 kit ordered at the end of 2021: Frame, bed, motion parts all good. Belts could have been a bit longer but appear to be genuine GT2. Spring steel sheet was single-sided textured PEI. I *think* it was advertised as dual-sided, so that was disappointing. I suspect...- Breaker1066
- Post #13
- Forum: Kits