VORON Design

Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members!

Recent content by BrettW

  1. BrettW

    Tridex Build - 400 x 400(ish)

    Thanks guys, didn't even consider that. After remeasuring and adjusting the rails it went from a 0.38mm variance to 0.28. So I think you're correct in it being skewed rails. Putting them equal distance from the top is close, but I think there's something slightly off with the frame, so I'll just...
  2. BrettW

    Tridex Build - 400 x 400(ish)

    Euclid Probe & Heated bed is installed & wired up. Euclid works really well, expected more jank from the docking system. The bed mesh is iteresting, there's a twist in the far side where it's only supported in the middle. Not sure what's causing it. It's there both cold and at temp.
  3. BrettW

    Tridex Build - 400 x 400(ish)

    Yeah, the bed is a bit too big. The frame and bed were purchased a while back and didn't consider it. My thinking was eventually full plate with 200x400 in duplication mode. I think I have just enough room to do some kind of custom wiper setup on the edges. It'll be a good excuse to get creative.
  4. BrettW

    Tridex Build - 400 x 400(ish)

    The kinematics is made for 400x400. The build plate is 400 x 400 as well, my thought process was that I could achieve 200 x 400 mm in mirror/duplication mode. But practical IDEX printing is probably closer to 300 x 400 mm. not sure what I'm going to do given that the release candidate design...
  5. BrettW

    Tridex Build - 400 x 400(ish)

    Been working on a large format Tridex. Currently its up to the point where I can home both tool heads and run some x/y tests. Frame assembled and x/y belted up. Reprinted the A/B drive mounts & idlers for the latest tridex release. Deck Panel Installed & Electronics bay wired up with mains...
Top