Recent content by bustergump

I thought the printer.cfg was automatically updated with new id, but I updated it manually and now connects. The differences between the example example BTT skr Mini E3 v3 and my print.cfg is that the x and y endstops are 0 in the example and 250 in my print.cfg. I had 0 values but, but a...

Had a bad 2209 driver. Replaced the bad BTT skr Mini E3 V2 with a BTT skr Mini E3 v3. Flashed the firmware several times came back firmware.cur everytime. Reinstalled Klipper. Getting same error. Please see attached files.

Same problem after switch. Must be the motor. I ordered a new one.

Powered up this morning. Tried to home. Y would not move, but vibrated. Stepper buzzed all axis. All good. Made some changes to the printer.cfg file in the BL touch. The changes were from a known working BL touch section of a Switchwire config file. Restarted, same issue. Researched the...

Thanks.

Trying to calibrate z offset. According to the Initial calibration documents use the Z_ENDSTOP_CALIBRATE command. I get an unknown command reply. When I use PROBE_CALIBRATE to lower the nozzle, I do not reach the bed. I get an out of range message. Tried TESTZ Z=-5 get a command unknown...

All axis home. Thank you so much.

Followed the instructions on the bltouch test page. All tests passed, until the G28 command. Extruder did the same as before. When to the bltouch section on the configuration reference page. Removed all lines except the required lines for the pins. Got an error that Z offset must be specified...

Thanks.

Also the bltouch pin is deployed, but never touches the bed, since the extruder moved in the other direction.

Thanks, made the change. X Y are now homing, but when I try to home z , the extruder moves to far right , closing the x endstop switch. The extruder then moves up and does not stop.

I am using this sample, which has 8 for the z rotation distance: https://github.com/Klipper3d/klipper/blob/master/config/generic-bigtreetech-skr-mini-e3-v2.0.cfg. Is there another file I should be using?

Making progress. X homes , Stepper test y: y stepper y cannot be found, Z passes stepper test. Checked the pin setting for y .Checked ok. checked that y cable is connected at both ends, ok. Y was working a few days ago. Changed the printer.cfg back to github sample. Only changes made were...

In desperation I thought that maybe the motor wires were reversed, so I changed them : All axis are now open, but extruder still moves to the upper lefthand corner. Now getting an error : No trigger on y after full movement. New printer.conf.txt attached.