Recent content by Chops

I didn’t. I just replaced the board with an a skr mini e3 v2 with a waveshare CAN hat on the pi.

Who knows. I like the idea of the pico, being able to use it as a can bridge and power the pi, it makes thing a lot neater. Do I roll the dice on another or use something else.

So starting over did nothing , same error. Then I reflashed again and set it up without CANbus same thing. Then I set up a skr mini e3 v1.2 I had laying around just to test the steppers and they worked. I’m starting to think this board is doa.

So wiring and pins are good. Im at a loss. I think I might just go full nuclear and re flash everything and see what happens.

1. Diag jumpers are there 2. I’m going to check when I get home from work also verify the stepper wires are pinned correctly on the motor side. They are ldo steppers so I’m guessing they are ok but I’m going to verify. 3. Power is there. I was powering the pi off the pico board with no under...

I dont know a better way of sharing this other than copying and pasting the whole config here.

So, Just finished building my v0.2 went to do the pre startup and buzz the steppers and I get this error ( Unable to read tmc uart 'stepper_x' register IFCNT ) anyone ever experience this before? Now this error happens for the y and z steppers also which leads me to believe its not a dead...